Quote:

---

Quote:

---

I just checked em out and it seems after welding, the boxes have bowed out an 1/8 in. at the bottom causing a slight bind on the bearings so back to the grind....

---

Pull them together with a C clamp?

---

That and a big hammer and all`s well and no more bind. They`re already welded in Mike. There`s a collar that`s the same od as the bearings inner that the bolt goes through so instead of the bearing taking the hit cornering, I found some washers slightly smaller than the outer diameter of the bearings and installed em on the inside of the bearings w/a slight gap and we`re golden. Don`t like the idea of the bearing takin the beating when the washer can better spread the load..........