I do have one question, is there any reason your leaving the piston to head @ .062" ?
I see your piston's are in the hole .011" and your using a .051" gasket.
The pistons just ended up .011 in the hole and I just thought I'd go with the Fel-Pro 1039 composite head gaskets. They work well for this bore and compression and were a lot cheaper than Cosmetics.
I didn't know where the pistons were in the block before ordering them. I'd rather run a .030 or .040 but I "think" .062 will work ok, let me know if you guys think I'm making a mistake and should go ahead and get a .040 Cometic gasket.
