Intake manifold bottom plate

Print Thread

Re: Intake manifold bottom plate [Re: busboy] #1558391 01/04/14 11:26 AM 01/04/14 11:26 AM
Joined: Jan 2003 Posts: 1,255 Columbus, GA Michael Ecks pro stock
Michael Ecks pro stock Joined: Jan 2003 Posts: 1,255 Columbus, GA	Quote: Sorry guys, should have mentioned it, LA small block(340). I am using a lifter valley plate so I think I should be alright without the one on the bottom of the intake?? Its been a long time, but... I seem to recall I took apart a stock one once that left the exhaust crossover passages basically exposed to the valley without the plate on the intake bottom. My memory may be off, but if that is the case make sure you block of the crossovers at the intake gasket surface REAL good. If it sealed up there, then yes the milodon or moroso valley tray will have you covered. "The happiness of your life depends upon the quality of your thoughts" ~ Roman Emperor Marcus Aurelius

Entire Thread
Subject	Posted By	Posted
Intake manifold bottom plate	busboy	01/04/14 02:29 AM
Re: Intake manifold bottom plate	80fbody	01/04/14 03:00 AM
Re: Intake manifold bottom plate	RapidRobert	01/04/14 03:34 AM
Re: Intake manifold bottom plate	ademon	01/04/14 03:41 AM
Re: Intake manifold bottom plate	80fbody	01/04/14 03:52 AM
Re: Intake manifold bottom plate	JohnRR	01/04/14 07:55 AM
Re: Intake manifold bottom plate	70Cuda383	01/04/14 08:37 AM
Re: Intake manifold bottom plate	busboy	01/04/14 02:59 PM
Re: Intake manifold bottom plate	Michael Ecks	01/04/14 03:26 PM
Re: Intake manifold bottom plate	Supercuda	01/04/14 03:33 PM
Re: Intake manifold bottom plate	busboy	01/04/14 04:02 PM
Re: Intake manifold bottom plate	Commando1	01/05/14 03:14 PM

Hop To