Some things I did not put in the outher post that I should have.
I use a 2" lowering block to get my ride highth and make it from aluminum bar stock. I mill the angle I nead to get my pinion angle. the pin is made from a 1/2" bolt cut off.
I allso run aluminum bushing in the front eye.
I use a pinion snubber It is home made from box tubing cut on an angle and longer than stock type, the rubber bushing is from a front limitor , you allways want the rubber to be tapered so as not to be a dead stop.
I am sure there are outher things I missed.