chamfer at top of cylinder 440 - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech chamfer at top of cylinder 440

Print Thread

Re: chamfer at top of cylinder 440 [Re: BeeSuper] #1467204 07/13/13 04:33 PM 07/13/13 04:33 PM
Joined: Feb 2005 Posts: 4,324 Prospect, PA BSB67 master
BSB67 master Joined: Feb 2005 Posts: 4,324 Prospect, PA	The chamfer is not going to make or break your CR. Has the block been decked yet to get to zero deck? Not sure about the ICON's, but it is not uncommon to need a 0.020" or so cut to get to zero deck. At that point, see what you have a get a 4.5" bore gasket.

Entire Thread
Subject	Posted By	Posted
chamfer at top of cylinder 440	BeeSuper	07/13/13 03:20 PM
Re: chamfer at top of cylinder 440	domingo	07/13/13 04:38 PM
Re: chamfer at top of cylinder 440	dodgeboy11	07/13/13 05:17 PM
Re: chamfer at top of cylinder 440	MR_P_BODY	07/13/13 05:29 PM
Re: chamfer at top of cylinder 440	BeeSuper	07/13/13 08:08 PM
Re: chamfer at top of cylinder 440	BSB67	07/13/13 08:33 PM
Re: chamfer at top of cylinder 440	Dunnuck Racing	07/13/13 10:45 PM
Re: chamfer at top of cylinder 440	Crizila	07/13/13 11:51 PM
Re: chamfer at top of cylinder 440	dodgeboy11	07/14/13 01:51 AM
Re: chamfer at top of cylinder 440	BeeSuper	07/14/13 04:27 PM
Re: chamfer at top of cylinder 440	dogdays	07/14/13 10:03 PM
Re: chamfer at top of cylinder 440	BeeSuper	07/15/13 01:33 PM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1