Hold your horses here on that diagnostic. Even with a cam thats slightly bent you will be able to get it slid in.

As was earlier posted, Bob, did the flip test and it was still a No go as Bob put it. The flip test totally eliminated any bend factor. The cam could of been bent 90* He was only test fitting the front bearing. Still, No Go!

Bobs flip test showed that at least the front bearing was to tight. Others may still be also.

The cam may be bent 3* , but thats not the only issue. A new cam wont fix it if the above tests were done.


Almost all the BB,s with new cam bearings will have fitment issues.