Chrysler Engineering Drawings with 0 inch reference

Print Thread

Re: Chrysler Engineering Drawings with 0 inch reference [Re: Alaskan_TA] #1417955 04/11/13 12:55 AM 04/11/13 12:55 AM
Joined: Jan 2003 Posts: 17,516 Las Vegas, NV 6bblgt OP I Live Here
6bblgt OP I Live Here Joined: Jan 2003 Posts: 17,516 Las Vegas, NV	Quote: The zero line - draw a straight line axle center to axle center - front to back. Are you sure? Wouldn't that ZERO-LINE change based on factory ride height & rear springs? (an AAR's 0-line would be different from a 383 'Cuda)

Entire Thread
Subject	Posted By	Posted
Chrysler Engineering Drawings with 0 inch reference	6bblgt	04/11/13 03:41 AM
Re: Chrysler Engineering Drawings with 0 inch reference	NITROUSN	04/11/13 04:16 AM
Re: Chrysler Engineering Drawings with 0 inch reference	Alaskan_TA	04/11/13 04:49 AM
Re: Chrysler Engineering Drawings with 0 inch reference	6bblgt	04/11/13 04:55 AM
Re: Chrysler Engineering Drawings with 0 inch reference	6bblgt	04/11/13 04:51 AM
Re: Chrysler Engineering Drawings with 0 inch reference	Alaskan_TA	04/11/13 04:56 AM
Re: Chrysler Engineering Drawings with 0 inch reference	Alaskan_TA	04/11/13 05:20 AM
Re: Chrysler Engineering Drawings with 0 inch reference	coffeeman383	04/12/13 01:22 PM
Re: Chrysler Engineering Drawings with 0 inch reference	MMC Detroit	04/12/13 11:00 AM
Re: Chrysler Engineering Drawings with 0 inch reference	MMC Detroit	04/14/13 02:43 PM
Re: Chrysler Engineering Drawings with 0 inch reference	coffeeman383	04/12/13 01:11 PM
Re: Chrysler Engineering Drawings with 0 inch reference	coffeeman383	04/13/13 05:39 PM

Hop To