Quote:


1. Can I use the rocker arm assy's? Should work

2. Can I use the push rods? Maybe depending on lifters and required length needed.

3. Can I use the oil pan? No.

4. It has a"thick" harmonic balancer, should I change this? Will belts line up? 413 should be steel crank. Sounds like you have a cast crank balancer. Mixed bag here so who knows what will line up??


5. Has a 6 hole crank, can I use my stock 4spd set up?

Better double check the crank. If its cast you will need the correct flywheel. From your balancer question you had better identify the crank. Also make sure there is a pilot hole.


It most likely will be a very low compression motor. I would be looking for a better motor.