Quote:

That is the preferred method I think. Locating off of the original front spring mounts makes it easy......which is why I did it the hard way.
I used a spring slider set up on the back instead of shackles , but either one will work for you.



Always a good idea to establish a true centerline with a plumb bob.
The original mounts aren't always true. Mine were off 1/4" side to side. Measure back from a 90 degree line to the true centerline. Then check the spring hanger mounts, torsion bar crossmember, and lower control arm pivots and see if all 3 match.
Doug