|
Re: Is there any reason
[Re: savoyracer]
#1360121
12/30/12 11:39 AM
12/30/12 11:39 AM
|
Joined: Jun 2003
Posts: 52,972 Romeo MI
MR_P_BODY
Master
|
Master
Joined: Jun 2003
Posts: 52,972
Romeo MI
|
Quote:
That I should not cut my Indy valley plate lengthwise in half. The plate fits under the Indy heads, and the only way to remove it, is either take off a head, or unbolt everything off the front of the engine, and slide it forward. I was thinking that I can make it a two piece valley plate, and it would simply lift out, then I can remove my lifters easily to be checked out. Then to reinstall, simply run a silicone bead down the joint and it will be good until next time. Anything wrong with this thought?
Myself, if I was going to make it removable I would cut it length way but I would make it so it over laps by welding a piece of alum to the lower part so you end up with a 1" over lap so you can drill and tap it for screws... put a bead of silicone on it and tighten it up.... JMO.... if you have access to a mill I would butt weld the piece and mill a step in both parts to give the over lap and it would go out on the china rails
|
|
|
|
|
|