Quote:

Quote:

are you trying to take it out w/o removing the intake? if you cut it from back to front I'd think it would seal very well as it would not be very stable. They sell units that have access plates so you don't have to go thru all of that.


............I will remove the intake, I just want to be able to get access to my lifters at that point without having to remove anything else. I have a machine shop here, that I use all the time, I was thinking of making the cut on a 45 degree angle, so it would simply slip back togather with silicone to seal it. Just don't know if this is a good idea or not.


I have a Bulldog two piece valley covers that is that way,I haven't used it yet so no valid input on how it works, sorry. I did try one of the two piece sheet metal steel valley covers , it didn't seal that well The single piece sheet metal steel valley cover that Koffels provides with there B1 kits could be slid out the front maybe, if you remove the distributor, I think I haven't used it yet either


Mr.Cab Racing and winning with Mopars since 1964. (Old F--t, Huh)