Does anyone make a gear lower than 3.54 for Dana 60?

Print Thread

Re: Does anyone make a gear lower than 3.54 for Dana 60? [Re: feets] #1226147 05/02/12 11:23 PM 05/02/12 11:23 PM
Joined: Jun 2005 Posts: 4,041 michigan woods imfixinmopars426 master
imfixinmopars426 master Joined: Jun 2005 Posts: 4,041 michigan woods	Quote: There was a 3.08 gear set for the 1990 D250 with a Cummins. They're pretty hard to find. careful! those are a special offset pinion case diff. huge pinion caused the offset,will not fit in a standard case. ck info on any "under 3.54" gearsets....the pinion may not fit!!! mike

Entire Thread
Subject	Posted By	Posted
Does anyone make a gear lower than 3.54 for Dana 60?	Hemi ragtop	05/02/12 10:57 PM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	AndyF	05/02/12 11:05 PM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	666	05/02/12 11:30 PM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	Chris2581	05/03/12 12:09 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	feets	05/03/12 12:17 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	YYZ	05/03/12 12:28 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	bp27	05/03/12 12:48 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	Cab_Burge	05/03/12 01:50 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	bp27	05/03/12 03:26 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	imfixinmopars426	05/03/12 03:23 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	446acuda	05/03/12 12:20 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	Dabee	05/03/12 04:11 AM

Hop To