Does anyone make a gear lower than 3.54 for Dana 60?

Print Thread

Re: Does anyone make a gear lower than 3.54 for Dana 60? [Re: bp27] #1226146 05/02/12 09:50 PM 05/02/12 09:50 PM
Joined: Aug 2003 Posts: 43,323 Bend,OR USA C Cab_Burge I Win
Cab_Burge I Win C Joined: Aug 2003 Posts: 43,323 Bend,OR USA	Quote: 1980-82 ford F250 hade 3.33 I think if you look on the center section you will see that it has 60-1 cast into it. Not quite the same as the standard Dana 60s I would like to find one of the Dana 60-1 out of a mid 1970 Ford 3/4 ton truck with the 360 V8 and the four speed truck trannys with the 3.30 gears in it, I would have it cut down for my Duster OP, how about using a lot taller tire on the rear to slow the cruise RPM down I did Mr.Cab Racing and winning with Mopars since 1964. (Old F--t, Huh)

Entire Thread
Subject	Posted By	Posted
Does anyone make a gear lower than 3.54 for Dana 60?	Hemi ragtop	05/02/12 10:57 PM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	AndyF	05/02/12 11:05 PM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	666	05/02/12 11:30 PM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	Chris2581	05/03/12 12:09 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	feets	05/03/12 12:17 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	YYZ	05/03/12 12:28 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	bp27	05/03/12 12:48 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	Cab_Burge	05/03/12 01:50 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	bp27	05/03/12 03:26 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	imfixinmopars426	05/03/12 03:23 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	446acuda	05/03/12 12:20 AM
Re: Does anyone make a gear lower than 3.54 for Dana 60?	Dabee	05/03/12 04:11 AM

Hop To