Ok so I picked up a rear end out of an old funny car that was narrowed and is an 8 and 3/4. It is back braced set up for a 24" rear frame four link.

Here is the thought. I would like to weld on 8 3/4 ends on grab up a new posilocker and new axels. I feel this can be strong enough and lighter than these hulk floater axels.

Or not to worry about the floaters and use the rear as is. It has nice disk brake system but again heavy.

Just looking to be used in a pro streeted street car with blowen big block.

Thoughts guys?

Cheers Don.