Quote:

Next shot is of the regulator. The supplied bracket is a little 90 degree plate for bolting (presumably) to the firewall or fender. Didn't want to do that. Had a spare throttle bracket (You might recognize AndyF's AREngineering throttle bracket) to use to mount regulator bracket to.

Due to the need to install the regulator, had to cut the hardline before the bend to the carb inlet, and make another piece to run aft, inward, then outward to go the regulator inlet. Hence, it's not all one piece of hardline to the regulator from the FVS. There is one hose section "joint" adjacent to the carb where I had to make the cut and slight flare so the hose clamps would have something to grab onto.




This picture the 180* bend is pinched pretty flat. This will cause problems.


1973 Charger, former SE, former auto

I'm not trying to be difficult, it comes naturally....