Quote:

I have used those same rockers (the unbushed comps) at 580 open seat pressure with zero problems. It's a solid roller .648 lift and [Email]262@.050.[/Email] I drive the heck out of it, and beat on it at the strip as well. The shafts are just whatever came with the rockers. I have never checked the side clearance, but there is not very much at all since I use the Hughes shaft hold downs. If I remember right, I had to mill a little off the sides of thos hold downs to get them to work.



For every 5 people that have a problem there will be one that doesn't no matter what the item. Glad they are working well for you. Did you modify the oiling to them, maybe go to full time ?

A70 this guy brings up a good point , what hold downs were you using and was it held down with bolts or studs ? I was talking to Dan/Performance Only about this yesterday ...