.080 5/16 pushrod strenght - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech .080 5/16 pushrod strenght

Print Thread

Re: .080 5/16 pushrod strenght [Re: robnbird] #1189541 03/03/12 12:21 PM 03/03/12 12:21 PM
Joined: Jan 2003 Posts: 4,616 Kissimmee Fl. D dusturbd340W5 master
dusturbd340W5 master D Joined: Jan 2003 Posts: 4,616 Kissimmee Fl.	Quote: Quote: my valve springs are set up at 590# open pressure. would an .080" wall thickness 5/16 pushrod be ok or do i need something heavier? don't take chances 590 spring pressure is enough to bend a 5/16 .080 PR. Go with a 3/8 .080. I was running over 700# with a 5/16x.120 wall with 0 problems and was spinning it to 8000,and Terry Manton assured me I would be fine,but they where a little short at just under 7.00 70 duster full chassis super pro 416 CNC Indybrock heads 727 w/brake best so far 1.212 60 6.219 in 1/8 at 110.88 9.768 at 137.81 1/4

Entire Thread
Subject	Posted By	Posted
.080 5/16 pushrod strenght	mopar dave	03/02/12 07:16 AM
Re: .080 5/16 pushrod strenght	Leon441	03/02/12 12:27 PM
Re: .080 5/16 pushrod strenght	tboomer	03/02/12 12:49 PM
Re: .080 5/16 pushrod strenght	dartman366	03/02/12 03:37 PM
Re: .080 5/16 pushrod strenght	Bob_Coomer	03/02/12 04:47 PM
Re: .080 5/16 pushrod strenght	ahy	03/02/12 04:53 PM
Re: .080 5/16 pushrod strenght	40ford	03/02/12 05:22 PM
Re: .080 5/16 pushrod strenght	mopar dave	03/02/12 06:25 PM
Re: .080 5/16 pushrod strenght	rickraw	03/03/12 12:48 AM
Re: .080 5/16 pushrod strenght	dusturbd340W5	03/03/12 01:30 AM
Re: .080 5/16 pushrod strenght	mopar dave	03/03/12 01:35 AM
Re: .080 5/16 pushrod strenght	robnbird	03/03/12 03:01 AM
Re: .080 5/16 pushrod strenght	mopar dave	03/03/12 03:48 AM
Re: .080 5/16 pushrod strenght	dusturbd340W5	03/03/12 04:21 PM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1