.080 5/16 pushrod strenght - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech .080 5/16 pushrod strenght

Print Thread

.080 5/16 pushrod strenght #1189528 03/02/12 03:16 AM 03/02/12 03:16 AM
Joined: Jan 2007 Posts: 8,048 Mt Morris Michigan mopar dave OP master
mopar dave OP master Joined: Jan 2007 Posts: 8,048 Mt Morris Michigan	my valve springs are set up at 590# open pressure. would an .080" wall thickness 5/16 pushrod be ok or do i need something heavier? http://www.youtube.com/watch?v=aIxaesJ190U http://youtu.be/lCZAaN7fFLg

Entire Thread
Subject	Posted By	Posted
.080 5/16 pushrod strenght	mopar dave	03/02/12 07:16 AM
Re: .080 5/16 pushrod strenght	Leon441	03/02/12 12:27 PM
Re: .080 5/16 pushrod strenght	tboomer	03/02/12 12:49 PM
Re: .080 5/16 pushrod strenght	dartman366	03/02/12 03:37 PM
Re: .080 5/16 pushrod strenght	Bob_Coomer	03/02/12 04:47 PM
Re: .080 5/16 pushrod strenght	ahy	03/02/12 04:53 PM
Re: .080 5/16 pushrod strenght	40ford	03/02/12 05:22 PM
Re: .080 5/16 pushrod strenght	mopar dave	03/02/12 06:25 PM
Re: .080 5/16 pushrod strenght	rickraw	03/03/12 12:48 AM
Re: .080 5/16 pushrod strenght	dusturbd340W5	03/03/12 01:30 AM
Re: .080 5/16 pushrod strenght	mopar dave	03/03/12 01:35 AM
Re: .080 5/16 pushrod strenght	robnbird	03/03/12 03:01 AM
Re: .080 5/16 pushrod strenght	mopar dave	03/03/12 03:48 AM
Re: .080 5/16 pushrod strenght	dusturbd340W5	03/03/12 04:21 PM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1