Quote:

#5 main feeds #8 rod
#4 main feeds #7 and #6
#3 main feeds #5 and #4
#2 main feeds #3 and #2
#1 main feeds #1

it would appear to me that you have a volume issue if you hurt #5 and #6 since they are fed off two different mains,,, what did #7 look like?

what kind of filter did you have on it,, ive seen restrictive filters hurt rods in th eback of the motor

the "typical" rod that gets hurt in a bb mopar is #3 usually



#7 looked like I had just installed it, like I previously stated. #6 wasn't there. #5 was there but burnt. ALL other rods and ALL mains looked like new. I usually use either a Fram HP1 of K&N hp filter. This time it had a Fram on it. I run a deep sump oil pan and a HV pump. Cold start up it sets on 98 psi. All warmed up and at idle it sets on 65 psi.

4 speed street legal. Best time 10.99 @ 124 mph on 93 octane pump gas @ 3926# total weight