Quote:
Any ideas what was wrong with that stock unit?
When you take the new one out to reclock it so it's pointing correct & to hookup the vac hose look at them side by side & compare the rotor/tang/pickup phasing. For instance holding both in your hands w the magnets lined up dead even w the same tooth on both are both bottom tangs parallel and are both rotors pointing the same like say 2 o'clock. That only leaves springs/slot length/amt of adv in each of the cans EDIT yes I would replace the heavy spring w long loop on one end & curve will need 2 be dialed in
Last edited by RapidRobert; 09/03/11 10:47 AM.
