Quote:
Original Poster
Quote:
It's a 23 spline and all I want to do is change the input shaft bearing. I was hoping to confirm if I could just unbolt the front bearing retainer and switch the bearing out.
JohnRR
Quote:
Maybe it's the the fact that the input shaft won't come out the front on a 23 spline that I was able to pull the bearing off without disassembling the trans, I popped off the snap rings and used 2 screw drivers against the case and was able to pull off the bearing.
JohnRR
Quote:
No you can't just swap it like that, would be nice if one could but it's not that easy.
Which JohnRR do I agree with? 
or is it disagree with? Oh heck I don't know.
It's your call obviously.
As said above it's not as simple as one might hope , obviously depends on how tight the press fit it , I do remember it took a bit of work to get it off and get it back on because of the press fit.
I would be opening that trans up to see how it looks and regasket it at minimum , see hown much junk flushes out .
Last edited by JohnRR; 06/03/11 02:09 PM.
