CLUTCH BALL STUD SEALS - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer CLUTCH BALL STUD SEALS

Print Thread

CLUTCH BALL STUD SEALS #260586 03/21/09 11:11 AM 03/21/09 11:11 AM
Joined: Sep 2003 Posts: 106 Central PA H Howard OP member
Howard OP member H Joined: Sep 2003 Posts: 106 Central PA	I'M TRYING TO PUT THE BALL STUD SEALS ON THE BALL STUDS,BUT WITH NO SUCCESS. I PUT SOME GREASE ON THE TIP OF THE BALL STUD AND ON THE SEAL BUT STILL CAN'T GET IT ON. THE HOLE ON THE SEAL IS ONLY A QUARTER OF AN INCH, IS THERE AN EASY WAY TO STRETCH THE SEAL LIKE HEATING IT OR SOMETHING?

Re: CLUTCH BALL STUD SEALS [Re: Howard] #260587 03/21/09 12:38 PM 03/21/09 12:38 PM
Joined: Jan 2003 Posts: 5,268 NY 7 70440+6bbl master
70440+6bbl master 7 Joined: Jan 2003 Posts: 5,268 NY	Just replaced the ones on my '70 'Cuda and they are a tight fit, but you will be able to get them on. After a few tries, they tend to stretch a bit more.

Re: CLUTCH BALL STUD SEALS [Re: 70440+6bbl] #260588 03/21/09 02:13 PM 03/21/09 02:13 PM
Joined: Mar 2003 Posts: 8,850 Central Coast, Calif. S Snoopy master
Snoopy master S Joined: Mar 2003 Posts: 8,850 Central Coast, Calif.	Put them in a glass of hot water and they will soften up enough to allow easy installation.

Re: CLUTCH BALL STUD SEALS [Re: Snoopy] #260589 03/22/09 12:41 AM 03/22/09 12:41 AM
Joined: Sep 2003 Posts: 106 Central PA H Howard OP member
Howard OP member H Joined: Sep 2003 Posts: 106 Central PA	I finally got them on I put needle nose pliers in the hole and opened it up wide enough to slip them on. Thanks Howard

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1