Small Block intake manifold - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer Small Block intake manifold

Print Thread

Small Block intake manifold #914524 01/26/11 05:06 PM 01/26/11 05:06 PM
Joined: Jun 2008 Posts: 251 Lithonia, Ga 3 36PLYM OP enthusiast
36PLYM OP enthusiast 3 Joined: Jun 2008 Posts: 251 Lithonia, Ga	Replacing intake on 318 with 340/360 heads. Got my choices down to four, all dual plane. 1) Mopar performance 2) Edelbrock Performer RPM 3) Edelbrock RPM Airgap 4) Crosswinds. Any input would help a lot, thanks! 36 Plymouth Coupe 318 w/360 heads 518 trans 8 3/4 rear Ga. Tech BCE'78

Re: Small Block intake manifold [Re: 36PLYM] #914525 01/26/11 05:10 PM 01/26/11 05:10 PM
Joined: Feb 2005 Posts: 28,312 Cincinnati, Ohio Challenger 1 Too Many Posts
Challenger 1 Too Many Posts Joined: Feb 2005 Posts: 28,312 Cincinnati, Ohio	Not the crosswinds...My favorite is the victor340. It runs better than the performer rpm, M-1 and a old Wieand single plane that I ran for a long time. I've tried these so far. my Last edited by Challenger 1; 01/26/11 05:11 PM.

Re: Small Block intake manifold [Re: Challenger 1] #914526 01/26/11 05:23 PM 01/26/11 05:23 PM
Joined: Jan 2003 Posts: 9,826 las vegas 70AARcuda master
70AARcuda master Joined: Jan 2003 Posts: 9,826 las vegas	eddy air gap....... Tony 70 AARCuda Vitamin C 71 Dart Swinger 360 10.318 @ 128.22(10-04-14 Bakersfield) 71 Demon 360 10.666 @122.41 (01-29-17 @ Las Vegas) 71 Duster 408 (10.29 @ 127.86 3/16/19 Las Vegas)

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1