thread contact - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech thread contact

Print Thread

thread contact #891296 12/29/10 05:25 PM 12/29/10 05:25 PM
Joined: Mar 2007 Posts: 12,008 Finally a HUSKER again Moparnut426 OP I Live Here
Moparnut426 OP I Live Here Joined: Mar 2007 Posts: 12,008 Finally a HUSKER again	So what is a known good thread count sticking out from the heads? Ive never used bolts, and I have ARP bolts for eddy heads, and they look short, but I might just not know what is normal for bolts. I have 3/4" of threads out the bottom of the head. Its accually only .618" with a washer and no head gasket. And for you guys wondering, YES I am a very questioning person. It just looked short to me. Kasey

Re: thread contact [Re: Moparnut426] #891297 12/29/10 07:51 PM 12/29/10 07:51 PM
Joined: Dec 2006 Posts: 2,113 Byron, NY W.I.N. Racing top fuel
W.I.N. Racing top fuel Joined: Dec 2006 Posts: 2,113 Byron, NY	length = 1 X Dia for Steel* 1.5 X Dia for Iron, 2 X Dia for Alu/brass (*material that the fastener will thread into) '01 P1500, Blown/Inj BAE,/Veney ,Bruno/CS2,Dana 60 '01 Dodge 3500 S Cummins Auto, Fresh air kit, 4" Exhaust, '05 Dodge Magnum R/T - Too Much to list '60 Willys CJ5 '01 International LPX - Project,DT466, Allison '64 Plymouth Valiant, Inj 528 Hemi, 2spd

Re: thread contact [Re: W.I.N. Racing] #891298 12/29/10 08:32 PM 12/29/10 08:32 PM
Joined: Mar 2007 Posts: 12,008 Finally a HUSKER again Moparnut426 OP I Live Here
Moparnut426 OP I Live Here Joined: Mar 2007 Posts: 12,008 Finally a HUSKER again	I just spoke with ARP, and they use the same bolt kit length wise for the eddy heads, and stock cast heads, and if you go to studs, they are longer and 2 different kits. I had him give me lengths for both bolts kit, and they were the same.

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1