Here are some pictures of my pro-touring project . I am aiming for a 600 hp gen 3 hemi, viper 6speed.

Adding the US Car Tool Frame connectors plus other braces

More pics

more pictures

boxing the upper inner fender well support area

Adding the lower core support brace

looking good, keep the pics and info coming..

Mark

Back from the sandblaster

another picture

Looks like you found a nice Cuda to use for the project. Should be a fun car when done. I'm pretty sure you & I stood in line together this year at Rockingham while waiting for the gates to open an HOUR late. Good luck.

Ahh yes. I remember that. Hope all is well.. Getting started on this one. Getting the body ready for the motor.

Will be putting my AAR clone up for sale to finance the drive train before long.

epoxy primer

other pic

Welding in the RMS street lynx rear coil over crossmember today.

welding in the PG classics rear torque boxes today.They needed some trimming to make fit

Thanks for sharing the pics. I'm particularly interested in this one as I have a 71 cuda restomod I am just finishing up. I'll be sure to keep an eye on this thread, so keep the pics coming as you have time.

It's looking great so far! Awesome job!

HOW DOES THE torque boxes FIT?? LOOKING FOR SOME FOE MY DART.

The Torque boxes required some fitting bending and trimming. In my opinion,if you are doing a resto correct car I wouldnt use them. I will probably make the next set instead of these.

Damm you guys for finding these 71 projects. Where did you find them?

Nice work!