Dana 60 front seal question - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Dana 60 front seal question

Print Thread

Dana 60 front seal question #848181 11/07/10 05:14 PM 11/07/10 05:14 PM
Joined: May 2005 Posts: 581 Texas Texican OP mopar
Texican OP mopar Joined: May 2005 Posts: 581 Texas	The front seal where the yoke connects to the driveshaft is leaking oil and I was wondering if it can be replaced without removing the entire gear set from the rear. Can it be replaced from the front? I hope I just overfilled it....but in case it's bad, I need to know what's involved to repair it. Thx

Re: Dana 60 front seal question [Re: Texican] #848182 11/07/10 05:16 PM 11/07/10 05:16 PM
Joined: Jun 2007 Posts: 2,646 Plymouth Meeting, PA bigtimeauto Trophy Winner
bigtimeauto Trophy Winner Joined: Jun 2007 Posts: 2,646 Plymouth Meeting, PA	yep, no problem to replace it. BB, TT5,Procharged 3300lb Street Car 4.79/154

Re: Dana 60 front seal question [Re: bigtimeauto] #848183 11/07/10 09:42 PM 11/07/10 09:42 PM
Joined: Jan 2003 Posts: 16,929 NC 440Jim I Live Here
440Jim I Live Here Joined: Jan 2003 Posts: 16,929 NC	Yes, It can be replaced no problem. The pinion preload is set by shims, so just make sure to tighten it up (a lot). 1993 Daytona, 5.50 at 130mph (1/8) 1.19 sixty ft (PG). Link to 572 B1 - Part 1

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1