Does any one have pictures or diagram of A body seat brackets? I am especially looking for how the spring attaches from the handle to the other bracket. I think I may be missing a piece.

I am trying to install what I think are factory A Body bucket seats into a car that originally came with a bench seat.

What year seats 70 to 72 no spring from one side to other, large spring goes from handle to a tab on same rail(inside), other side of track uses a wire from side to side, each track should have a small yellow spring that goes on the outside and the large spring on the inside. pass side seat wire passes through a long retainer that hooks on a loop on front side of seat.

Ademon, I have a 70 Duster. I am not sure what year the seat brackets are out of. I am missing the wire you describe and an ability to "lock" the non-handle side of the bracket. Trying to figure out how to make this work.

after 72, the non handle side did not lock or have a wire that connected the two sides, post a pic

Here is a picture of the seats brackets on Drivers seat. I installed the passenger seat and it does not lcok very well.

Here is another picture of the seat with the non handle track highlighted where I think I am missing a piece?

Can anyone identify these tracks?

I think I may need new ones if I can not figure out a way to make non handle side lock.

those look like 73 and later seats, the non handle side does not lock, are there any "teeth" on the track without the handle?

Yes there are teeth in the track with no handle.