Okay, these are going into the Demon:
Wilwood tandem plastic resevoir master cylinder (2 outlets, one front circuit, one rear circuit)
Wilwood 10lb residual valve (discs in the edit:
front, drums in the
back)
Wilwood adjustable proportioning valve
My question lies with the residual valve. The instructions say to "install after the tee fitting," but is that if you have a single outlet master cylinder, or do I still need to install it behind the distribution block in the middle of the lines?
This site (http://www.foundationpc.com/stories/brakes.html) says that the "junction box" (tee fitting?) doesn't connect the lines. Does the residual valve have to go behind it, or can it just be run like this:
(purple ends toward brakes)