340 six pack linkage question? - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer 340 six pack linkage question?

Print Thread

340 six pack linkage question? #357199 06/24/09 10:12 PM 06/24/09 10:12 PM
Joined: Jan 2003 Posts: 2,252 New York rarefish OP top fuel
rarefish OP top fuel Joined: Jan 2003 Posts: 2,252 New York	I just reinstalled my carbs after a rebuild and I went to reattach the linkage that connects the outboard carbs the the center one. It seems like something is missing where the linkage goes into the crescent shaped slot on the center carb. Check out the picture. There is a small nylon ring behind the cotter pin that seems to be too loose. Any ideas? 5313469-DCP_3516.JPG (71 downloads)

Re: 340 six pack linkage question? [Re: rarefish] #357200 06/24/09 11:13 PM 06/24/09 11:13 PM
Joined: Mar 2003 Posts: 15,491 the boonies aarcuda I Live Here
aarcuda I Live Here Joined: Mar 2003 Posts: 15,491 the boonies	Quote: I just reinstalled my carbs after a rebuild and I went to reattach the linkage that connects the outboard carbs the the center one. It seems like something is missing where the linkage goes into the crescent shaped slot on the center carb. Check out the picture. There is a small nylon ring behind the cotter pin that seems to be too loose. Any ideas? there is a sleeve with a lip on it that goes in the slot on the center carb. i think i see the rim of it under the lip of the stud there- the second washer looking thingie from the top. i'd have to go out to the shop to make sure what mine looks like. take a picture of all the parts disassembled and i can tell better

Re: 340 six pack linkage question? [Re: aarcuda] #357201 06/25/09 09:49 PM 06/25/09 09:49 PM
Joined: Jan 2003 Posts: 2,252 New York rarefish OP top fuel
rarefish OP top fuel Joined: Jan 2003 Posts: 2,252 New York	Does anyone have a picture of what the linkage should look like??

Re: 340 six pack linkage question? [Re: rarefish] #357202 06/29/09 11:31 AM 06/29/09 11:31 AM
Joined: Mar 2003 Posts: 5,193 NEW JERSEY AARCONV master
AARCONV master Joined: Mar 2003 Posts: 5,193 NEW JERSEY	the way u have it there is like mine except the nylon thing that does not belong.. my setup is as follows stud through the carb linkage flat washer front rod rear rod flat washer cotter pin same as yours...lose the nylon thing hope this helps...can't get a close up picture clear as yours

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1