1965-1976 A body Front Spindle Lock Nut Kit. Used, $6.50 + Shipping, Payment via US Postal Money Order Only! Shipping: US Address Only!
Call Steve 810-629-1097
Note: 3 Available

Rear speaker harness 2889614. Used, $20 + Shipping. Payment via US Postal Money Order Only! Shipping: US Address Only!
Call Steve 810-629-1097

A Body Rear Window Defrost Vent. Used $60 + Shipping. Payment: US Postal Money Order Only! Shipping US Address Only!

A Body Rear Window Defrost Hose Clamp. Used $15 + Shipping. Payment: US Postal Money Order Only! Shipping US Address Only!

A Body Rear Window Defrost Blower Motor. Used, $75 + Shipping. Payment via US Postal Money Order. Shipping: US Address Only!

Call Steve 810-629-1097

1971-78 Dodge Plymouth Chrysler Cruise Control Lever 3746518. Used, $50 + Shipping, Payment via US Postal Money Order Only! Shipping: US Address Only!
Call Steve 810-629-1097

72-76 B Body Rear Marker Light. Used $10 + Shipping. Payment via US Postal Money Order Only! Shipping: US Address Only!
Call Steve 810-629-1097

67-76 A Body Trunk Deck Lid Latch, Used, $10 + shipping. Payment via US Postal Money Order Only! Shipping: US Address Only!
Call Steve 810-629-1097.

67-76 A Body Black Front Kicker Panels #1-2663129, #1-2663128, Used, Both Panels $60 + Shipping, Payment via US Postal Money Order Only! Shipping: US Address Only!
Call Steve 810-629-1097

68-69 440 Unsilenced Air Cleaner With K&N Filter. Used, $275 + Shipping. Payment via US Postal Money Order. Shipping: US Address Only!
Call Steve 810-629-1097

Rear trailer tie down brackets for most A, B, or E body vehicles (doesn’t fit the 7 ¼ rear axle). These piggyback onto the bottom of the stock shock plate mounting nuts and then 4 more nuts hold these tie down brackets on. You must have enough extra thread hanging down on the bottom of your U-bolts to fit the ¼” thick tie down bracket and another nut. No disassembly necessary, just slide the brackets over the extra thread on your U-bolts, install the included nuts, tighten them down and you’re done. Takes about 10 minutes to install. These eliminate all the hassles that come with using axle straps. Fits A, B, and E body cars with the standard shock plates like shown in the pictures. $60.00 per pair plus shipping. I also have these available for cars with CalTracs, same price. Made in the USA.
Email mrrandyj@aol.com

I have a 1971, A body, A833 4 speed OD transmission.

Vin info: 1B160475, 1971 Hamtrack -
PP833 3330 0097
New Process Gear Division Plant, 833 Manual 4 Speed
3330 Sept 9, 1970 - 0097 trans made that day.

$400
local pickup only - I live near Annapolis MD, (I can bring to Carlisle)
PM me if interested.

1970 340 intake manifold, nice used condition $250.00 (708) 288-2879

NOS "PLYMOUTH" hood emblem for 71-74 with what's left of the wrapper, this is the stick on style......$50

Thank you

716-997-0070

bakurruda@aol.com

NOS Chrysler Starter, excellent condition, $225

Email Kenei@comcast.net

1968 Dart GTS Door Panel Emblem
Used, all 3 mounting prongs are intact.
...$100. Shipped in USA
Payment is USPS money order or Cash on pickup.
PM me worldwide.
Email me pursuitison@live.com

Mr. Norms - Dream Motors Super Charger vintage sticker - $40 - Will sell unframed for $25

NEW - Pack of (3) different Master cylinder gaskets ; 2) foam 1) gasket material - $6

NEW- Power steering return hose/clamps - $10

NEW - A BODY Fresh air vent to cowl seal (DMT) 63-66 fresh air vent to cowl, 67-76 NON A/C heater box to cowl, 67-72 AC heater box to cowl $8

NEW - Horn buzzer relay (aftermarket) - $15

NEW - Header bolts hex head (9) - $10

NEW - 69-74 brake distribution block part #BLK250 - $60

NEW - (rebuilt) by Brake/Equipment Warehouse in MN - Weatherhead brake distribution valve - $200

NEW - 72-76 A body Rear axle brake line brass T (no bolt) - $15

NEW - 1970-71 340-440 Carter AVS Idle solenoid bracket - $30

NEW - LARGE chrome master cylinder cover with bail wire - says "WARNING - clean filler cap before removing, use only DOT3 fluid from a sealed container" - $25

USED - misc. seat belt mounting bolts x 12 - $20

USED - freshly refurbished A body blower motor mounting bracket to firewall with new gasket - $30


****PM IF YOU NEED TO SEE CLOSE UP OF A PARTICULAR PART - THANKS****

1966 Plymouth Barracuda Center Grille Emblem

...Used OEM Part# 2582427, has some pits / blemishes.

Overall it will display NICELY on your Cuda!!!

1 prong is broken off but it will secure to your grill just fine or try repairing it to your liking......Fish is tightly in place!!!

.......$100. + shipping....Payment is USPS money order or Cash on pickup

NOS 1971 Plymouth Duster owners manual, NOT REPRO.......has slight yellowing,but otherwise NICE NOS, tight, unwritten in and with the perforated page to fill out and tear off to send in the Chrysler Motors Corporation...........$40

Thank you

716-997-007


bakurruda@aol.com

833 4 speed transmission for A body. Transmission was gone through by previous owner and I pulled the cover after purchasing and everything looks good. I bought a new side cover gasket and bolted it back on but if someone wants to come see it we can pull it off again to look inside if they'd like. Housing is super clean and input shaft is nice as well and hasn't been cut. I just realized I will likely never use as I am more of a B body guy at this point. $1200.00 obo. Local pickup in Southwest Michigan. Please PM me if interested. Thanks,

Used console for a mopar. Not sure what it originally came out of. Has lock but is frozen (Button doesn't push down). Asking $200, buyer can pick up in Keymar, MD or pay shipping cost.

I have a nice set of 1970 A body bucket seats up for sale. These are above average seats today. Nice solid frames, nice solid tracks, only has one broken stud on drivers side seat.
They have all four of the hinge covers, but the passenger seat inside hinge cover does appear to have a small crack. I have this pictured and I am sure could be repaired while seats are apart being restored.
These seat are for 1970, but are the same frames for early 1971 cars. I have additional photos I can email those interested.
I am asking $800.00 or close offer for the pair. They are located in Cookeville, TN or I can deliver to the Indy cylinder head swap meet with a deposit. I am selling these as cores to restore If you’re interested please send me a PM.
Thanks, Matt