|
Re: 69 coronet neutral/ reverse harness routing
[Re: cudadon]
#3063803
07/30/22 08:35 AM
07/30/22 08:35 AM
|
Joined: Sep 2005
Posts: 232 Tennessee
CUDASCOTT
enthusiast
|
enthusiast
Joined: Sep 2005
Posts: 232
Tennessee
|
Thanks cab. Do you know if there is a tab or clip of some kind on the tunnel? There was no harness so I'm trying to make it right. Thanks, mopar to ya It doesn’t clip to the sheet metal. There’s clips that attach to the trans and ones that go under the bolts that attach the trans to the block.
Last edited by CUDASCOTT; 07/30/22 08:43 AM.
|
|
|
Re: 69 coronet neutral/ reverse harness routing
[Re: CUDASCOTT]
#3063868
07/30/22 01:17 PM
07/30/22 01:17 PM
|
Joined: Oct 2008
Posts: 116 Midwest
MoparsnMissiles
member
|
member
Joined: Oct 2008
Posts: 116
Midwest
|
That pic you swiped is my photo that I posted on another website when someone asked about the same question. That's my engine/transmission I built and I just added the black line to indicate approximately where the harness runs. Clips are under the engine/trans mating bolt and tail housing bolt. Not on the body sheet metal. If you look closely you can see the two metal clips that hold the harness in place.
Last edited by MoparsnMissiles; 07/30/22 01:19 PM.
|
|
|
|
|
|