I just purchased a 426 Hemi six pac intake from Indy Cylinder Head.I can't wait to try it. Is anyone running this intake? I would appreciate your input.
Thanks Bob

hi
show us a pic .

does it look like a stocker or aftermkt appearance?

how much ?

is it a mopar piece or indy part ?

It is made by Indy, it is a single plane ,not dual plane, it has an interchangable top.It doesn't look stock. Cost was $595.00 plus freight.
I can't wait to run it.

does it look like this one???

Hi Ron where did you get your 6 pac intake?
How is the weather in sunny Escondido?
I am tired of the snow up here in Utah, there are days when I really miss Vista!

does it look like this one? {quote}





The Dayclona Hemi Sixpack manifolds are based on a factory dualplane design of the 66-71 street Hemi manifolds, my manifolds are a true dual plane 6 pak design, not an adapter plate,.... plus my manifolds retain the factory coil bracket location, and heat tubes.......Would be nice to see a pic of Indy manifold with the top off?.....Bob?


That indy being a straight runner design, I'd say your going to need some serious "jetting" on all 3 carbs?........I'd be interesting to see the outcome of your installation?......keep us posted Bob



Mike

Mike,
How much are your manifolds? Can you show a picture of the manifold by itself, less carbs?

and maybe some bigger pictures of ones installed, more resolution and detail?

Bob, here's a side shot of a Dayclona manifold showing the linkage/throttle/etc,.......looks like your going to have to fab some custom brackets up to work off the runner bolt/bosses, as the Indy manifold appears to have no "factory style" bracket bosses, but dose have bosses around each runner, so that should make your job easier.......

Mike,
How much are your manifolds? Can you show a picture of the manifold by itself, less carbs?

---

Snoop,.....I get $1200 to produce a bare manifold, each one is individually made, no mass production!,....so your paying for my manual labour time on a milling machine, and hand porting not a CNC program, throttle brackets are custom, and are a blend of Hemi and sixpack style, to make them unique to the manifold, factory aircleaners/ coldair systems fit,......... because the Hemi manifold has no provisions for a choke, the center carb either goes without, or uses a custom choke set-up like a factory 71 only Hemi E/B body manual dash set up,.......


I have some bare manifold shots,....I'll have the kid "upload/download"? .....I can post pics, but other "puter" stuff I leave to the kid, so I don't screw it up!

Also would like to see the bottom of that Indy intake.

I will take a couple of pics tommorrow morning.

Here is the new pic

Here is another new pic

Thanks Bob!.......is there a divider wall or plenum divider ridge in the center, running fore to aft on the manifold?,.....or is this baby just a huge open expanse under that adapter plate??????

So whose is this one?

Mike , it is just a huge open whole/canyon no divider. Bob

John , I would love to know. How is the weather in Cal., it is snowing up here today!!!