Has anybody here know of where to buy or how to make a clutch pedal stop.This is for my 1972 Demon.

Thanks...........Ted

Brewer performance..

I made one for my wife's Challenger. Used aluminum stock. One piece of 3" x 1 1/2" x 1/4" for the pad that hits the floor. Two 1" x 1/4" x 8" uprights with holes drilled every 1". The uprights are welded 90 degrees to the pad so the pedal arm slides in between them. The bolts go thru the uprights above and below the pedal arm clamp it. The multiple holes allow adjustment up or down. Helped my R/T a bunch when I was racing it.
Doug

I welded a 1/2" nut onto the clutch pedal and adjust it with a 3" long bolt.

Here's the bolt-on one I made.

How is that part attached to the pedal.

Ted

A slot is machined in the aluminum block and the pedal lever sits in the slot, a set screw on the other side of the pedal lever holds it to the lever.