Magnum rocker arm alignment

Print Thread

Magnum rocker arm alignment #265778 03/25/09 01:39 AM 03/25/09 01:39 AM
Joined: Jan 2003 Posts: 554 Mesa , Az Jambbii OP mopar
Jambbii OP mopar Joined: Jan 2003 Posts: 554 Mesa , Az	So I am building a 360 magnum engine with edelbrock heads for my friend. This is my first time playing with one of these engines. Anyways I am having issues with the rocker arms aligning up strait with the top of the valve stem. They seem crooked but only on one cylinder head. Is it ok if I offset the guide plates a little bit by pulling the studs and ovaling out the holes? Thanks, Josh 5117162-P3240437.JPG (192 downloads) 70 Challenger 1960 Town Wagon P Pump 24v cummins project 06 Mega 3500 Drw 2wd 12 Durango R/T 18 Power Wagon 67 A100

Re: Magnum rocker arm alignment [Re: Jambbii] #265779 03/25/09 10:58 AM 03/25/09 10:58 AM
Joined: Mar 2005 Posts: 166 Caldwell. Id E edbux member
edbux member E Joined: Mar 2005 Posts: 166 Caldwell. Id	Look on hughes. I remember seeing a write up on your issue in the tech section. web page Last edited by edbux; 03/25/09 10:59 AM. 1967 Dart 270 360/727

Hop To