Started ordering parts - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Started ordering parts

Print Thread

Started ordering parts #259622 03/19/09 10:19 PM 03/19/09 10:19 PM
Joined: Mar 2003 Posts: 753 San Diego, CA B brktracr OP super street
brktracr OP super street B Joined: Mar 2003 Posts: 753 San Diego, CA	I got my World Iron block, 4.49 rough bored. So I had to start ordering parts for it. 4.50 custom Ross gas ported pistons Total seal ring pack with .043 top and second ring New valve springs good to .800 lift Cam 720 / 700 lift 274 / 282 @ .050 4.15 crank is at the shop being ground .010 and re-nitrated. Bought a Mr. Gasket vacuum pump for this lil' puppy. Indy SR's ported by IMM. I figure this should get 600 h.p., don't you think 1.298 60 ft 6.001 1/8 mile 114 mph 9.52 1/4 mile 140.87 mph @ 3110 lbs

Re: Started ordering parts [Re: brktracr] #259623 03/19/09 10:23 PM 03/19/09 10:23 PM
Joined: Dec 2007 Posts: 10,542 BROOK PARK, OH WILD BILL Senior Member of the Junior Dragster Club
WILD BILL Senior Member of the Junior Dragster Club Joined: Dec 2007 Posts: 10,542 BROOK PARK, OH	Quote: I figure this should get 600 h.p., don't you think Only if you build it wrong I would think it could make a whole lot more

Re: Started ordering parts [Re: WILD BILL] #259624 03/19/09 10:53 PM 03/19/09 10:53 PM
Joined: Mar 2003 Posts: 753 San Diego, CA B brktracr OP super street
brktracr OP super street B Joined: Mar 2003 Posts: 753 San Diego, CA	Ok, maybe 650 h.p.? 1.298 60 ft 6.001 1/8 mile 114 mph 9.52 1/4 mile 140.87 mph @ 3110 lbs

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1