What lines to vent covers to vent tank - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech What lines to vent covers to vent tank

Print Thread

What lines to vent covers to vent tank #2458082 02/26/18 09:24 PM 02/26/18 09:24 PM
Joined: Feb 2006 Posts: 698 Alberta Canada E Edge OP mopar
Edge OP mopar E Joined: Feb 2006 Posts: 698 Alberta Canada	What hose should I use for venting my valve covers to the breather tank. Hoses will run length of vehicle as the vent tank is located in the rear. Fitting off off the valve covers are 1 1/4 od and the hose need to be flexible to work it way through the car thanks 76 Duster work in progress

Re: What lines to vent covers to vent tank [Re: Edge] #2458106 02/26/18 10:01 PM 02/26/18 10:01 PM
Joined: Feb 2018 Posts: 9 Florida C Charged392 member
Charged392 member C Joined: Feb 2018 Posts: 9 Florida	On my scavenger setup I am using -10/12 AN pushlock line.

Re: What lines to vent covers to vent tank [Re: Edge] #2458217 02/27/18 01:10 AM 02/27/18 01:10 AM
Joined: Oct 2007 Posts: 4,206 New York polyspheric master
polyspheric master Joined: Oct 2007 Posts: 4,206 New York	As big as you can fit to keep the air speed down. If possible, the line should be all downhill so the droplets don't drein back. That would be $1,000 for bullet proof, braided tungsten carbon fiber, or $12 for PCV and hose clamps. Boffin Emeritus

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1