Anyone out there with a Hemi E body with original motor mounts and correct K member give me the following measurements?
1) Top of K member to center of crankshaft
2) Drivers side framerail to center of crankshaft
3) Passenger side framerail to center of crankshaft
Also does the engine sit level from front to back or is there a degree of angle?

Any help appreciated.

Want help?
Get rid of that old crappy Dodge.
I'll give you 50 bucks.

TTI supplied that information on my header instruction sheet for my 440 in a 1970 e-body. They want to be sure you engine is in the stock location to eliminate fitment problems. Look on their website for the PDF version of their instructions for the Hemi and you'll probably find it.

Hey Boston! Im suprised you would go as high as $50 you cheap bas7ard!

Thanks for the reply jbc426. I have the tti instructions but they do not say what the distance should be from right and left frame rail only that they should be 2 1/2 inches difference. I an looking for the exact measurements.

For what it's worth, mine looks like roughly 14 1/4" from the passenger side and about 17" from the driver's side frame rails, but when there was less stuff in the way I measured and there was almost exactly 2 1/2" difference.

Thank you! Thats exactly what I have too