Think we are finally seeing some light at the end of the tunnel. Need to revise some oil line issues as I'm losing prime. But other than that car seems great. Special thanks to my wife Carrie for her patience & especially my Brother John, who w/out his help we wouldn't be this far along.
Thanks, Ken

Man, that sure is a nice looking ride. Has it made its maiden voyage yet?

No hoping for next Friday, Quaker city has test & tune sessions then. Low deck 474 w/Indy -1 heads.

Good looking Daytona!

Beautiful. I like it.

Bad ass..........can't wait to hear the results..........

Best of luck with your first outing, car looks great !

I have always liked these car when set up proper..great job keep us informed.. on how she runs... is this a chromoly build or mild Steel

looks killer i have a car like that

looks killer i have a car like that

if your loosing the prime I assume its a line kit from the pan make sure the lines are positioned with a loop to prevent drain back. I had that same issue. not fun! cost $$. my $.02

Yes it is a single line losing the prime. Maybe I will just order some line & fittings today to be safe. Thanks for the input. John aka Pittsburgh racer had mentioned a few on here had issues. Did you just make a simple loop in the line?? That's why I mentioned it so someone would chime in, thanks again.
Ken

Probably looks like crap to some on here but I never had an issue...

Looking good!👍👍👍

thats a loop ! could be a little longer of a line. If it does the job its all good!

Sorry guys, got this car from John Cadamore aka Pittsburgh Racer here. It's a Morrison chassis mild steel. Ordered line to use a full loop & a 60 degree fitting like above to go into the pump itself. Hopefully that will clear up all the issues.

The last time the chassis was certified I had it upgraded and passed 7.50 cert. so when Ken is ready all he needs is a fresh inspection.

Good looking ride Ken, you and your brother did a nice job!! Can't wait to see you go down the track in it.

Terry n Barb

Cpl more shots of the Daytona. Oil & fuel lines will be here tomorrow to finish things up
Ken

Engine shots