Need to identify what correct plating process should be done on the following items on my 69 charger project.

1- hood latch, actuator pivot lever, control rod.

2- secondary hood latch

3- trunk latch

4- door latches, strikers, shims, and screws.

Is there any other items I should consider?

Don't know if this will help...Plating guide written by Frank Badalson. Muscle Car Review, September 2001 issue.

pg 2

Pg 3

Thanks Wayne. Now I just need to figure out exactly what process was used on each part.

Kool. Hope this gets put in the archives.

next question...who does that type of plating? I have a bunch of stuff I need to get plated as well....