|
|
Re: Need a little help with 440 bearings
[Re: VernMotor]
#1877471
07/24/15 07:54 PM
07/24/15 07:54 PM
|
Joined: Jan 2003
Posts: 15,439
Val-haul-ass... eventually
BradH
Taking time off to work on my car
|
Taking time off to work on my car
Joined: Jan 2003
Posts: 15,439
Val-haul-ass... eventually
|
Just to be clear, you need .020" undersize rod & main bearings for an RB crank w/ radius fillets, right? EDIT: Nope, don't see any that'll cut it OOB. I suspect you may need to resort to using standard Clevite 77 or Sealed Power CP-series .020" rod bearings & .020" full-groove main bearings, some fixtures like these HERE, and finding someone w/ a lathe to narrow them, assuming you don't have a lathe yourself.
Last edited by BradH; 07/24/15 08:13 PM.
|
|
|
Re: Need a little help with 440 bearings
[Re: VernMotor]
#1877647
07/25/15 01:44 AM
07/25/15 01:44 AM
|
Joined: Jul 2010
Posts: 417
reynoldsburg,ohio
poppaj
mopar
|
mopar
Joined: Jul 2010
Posts: 417
reynoldsburg,ohio
|
You can chamfer them yourself, small half round file, it don't take much to clear chamfer
AA/NSS 65'Coronet "Whompin Wedge"
Pop & Son Performance 557" B-1 power
John Holt Chassis
|
|
|
Re: Need a little help with 440 bearings
[Re: BradH]
#1877886
07/25/15 03:22 PM
07/25/15 03:22 PM
|
Joined: Nov 2003
Posts: 7,348
Mt.Vernon ,Ohio
VernMotor
OP
master
|
OP
master
Joined: Nov 2003
Posts: 7,348
Mt.Vernon ,Ohio
|
Just to be clear, you need .020" undersize rod & main bearings for an RB crank w/ radius fillets, right? EDIT: Nope, don't see any that'll cut it OOB. I suspect you may need to resort to using standard Clevite 77 or Sealed Power CP-series .020" rod bearings & .020" full-groove main bearings, some fixtures like these HERE, and finding someone w/ a lathe to narrow them, assuming you don't have a lathe yourself. OK thank you ..this what I needed to know..
|
|
|
|
|
|
|
