Where on the 833 Trans were the clips put originally?

Pictures appreciated.

http://www.ebay.com/itm/380724212373?ssP...49#ht_335wt_679

This is a terrible lo-res diagram from a service manual (not my photo). I couldn't find it in my digital copy, so hope this helps.

That helps thanks.

It looks like there's another type of harness clip on the bellhousing as well. I'd like to see what they look like as well.

Somebody a while back had that same picture, and one for a Hemi, and it had one or two extra clips, that is if you were doing a Hemi.

Here is the clip that goes on the bell housing, it goes under the bolt that is in the 1:00 position (first bolt right from center if you are facing the rear of the engine). It was installed before paint so got paint over spray on it.

Clip

Thanks for the help guys.