Cylinder head guys ??? - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech Cylinder head guys ???

Print Thread

Cylinder head guys ??? #1336095 11/16/12 01:15 PM 11/16/12 01:15 PM
Joined: Mar 2007 Posts: 12,008 Finally a HUSKER again Moparnut426 OP I Live Here
Moparnut426 OP I Live Here Joined: Mar 2007 Posts: 12,008 Finally a HUSKER again	When putting a fresh set of heads together, do you like to lap the valves, or not? I was tought to in college that is was a good idea to do a light lap with fine compound, but Ive also read and seen where guys dont like to at all. Ive taken brand new heads from edelbrock, and the 906 heads from arrow heads and they werent lapped at all. Kasey

Re: Cylinder head guys ??? [Re: Moparnut426] #1336096 11/16/12 01:31 PM 11/16/12 01:31 PM
Joined: Jul 2004 Posts: 19,317 State of confusion T Thumperdart I Live Here
Thumperdart I Live Here T Joined: Jul 2004 Posts: 19,317 State of confusion	When I worked at Pettis and George K. racing, we always lapped em in more so to check to see how concentric the valves/seats were than to achieve a finish.......... 72 Dart 470 n/a BB stroker street car `THUMPER`...Check me out on FB Dominic Thumper for videos and lots of carb pics......760-900-3895.....

Re: Cylinder head guys ??? [Re: Thumperdart] #1336097 11/16/12 01:37 PM 11/16/12 01:37 PM
Joined: Mar 2006 Posts: 9,910 Eighty Four, PA B G Racing master
B G Racing master Joined: Mar 2006 Posts: 9,910 Eighty Four, PA	Most guys like to run a narrow seat angle on race heads and use machinist dye to check the seat for location and seal. [IMG]http://i430.photobucket.com/albums/qq21/ajcasini/max_zpsdppwd9km.jpg[/IMG]

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1