six pack idle screws - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer six pack idle screws

Print Thread

six pack idle screws #1329246 10/31/12 06:24 PM 10/31/12 06:24 PM
Joined: Sep 2006 Posts: 1,139 West Tennessee R rbstroker OP super stock
rbstroker OP super stock R Joined: Sep 2006 Posts: 1,139 West Tennessee	Is there any way to get the idle screws out of six pack carbs after the screw heads have been boogered up?

Re: six pack idle screws [Re: rbstroker] #1329247 10/31/12 07:32 PM 10/31/12 07:32 PM
Joined: Jan 2003 Posts: 9,436 Blair County,PA 62maxwgn master
62maxwgn master Joined: Jan 2003 Posts: 9,436 Blair County,PA	Yes,I have about 95% success getting them out,the other 5% I end up installing an insert to repair the base. 7443218-PA310551.JPG (89 downloads)

Re: six pack idle screws [Re: 62maxwgn] #1329248 11/01/12 09:42 AM 11/01/12 09:42 AM
Joined: Sep 2006 Posts: 1,139 West Tennessee R rbstroker OP super stock
rbstroker OP super stock R Joined: Sep 2006 Posts: 1,139 West Tennessee	Tell me more. This is the land of the free because of the brave

Re: six pack idle screws [Re: rbstroker] #1329249 11/02/12 03:38 PM 11/02/12 03:38 PM
Joined: May 2008 Posts: 119 Brownsburg, IN. U.S.A. S speedjunkee member
speedjunkee member S Joined: May 2008 Posts: 119 Brownsburg, IN. U.S.A.	I have a jig setup on my Lathe that I use. Richard Dodrill SpeedJunkee's Carbs and Performance 108 1/2 Grant St Brownsburg, IN. 46112 317-292-3814 speedjunkeecarbs@comcast.net

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1