can anyone give me some info on removing the rear quarter glass on my 70 superbee..this is a post car glass pops out..not the roll down window..thanks espo426@aol.com

You might find some photos that show this very same situation here:

http://www.musclecarrestorations.com/cars.php

They post photos of two '70 Super Bees they resored. Some of their cars have hundreds of photos, maybe to prove their billing is correct?

Can't say they are dedicated to originality though, since they put a lot of black paint on parts that were originally bare, like strut rods and upper control arms, and they zinc plate just about all the fasteners. Their pholosophy is "restoring a car (the) way he (the owner) wanted it done and in a way that it would stay restored." Emphasis on STAY.

BTW, you did check the factory service manual?

When I removed the glass in my 69 Bee coupe, it was held in by 4 screws on the inside. 3 at the front, and 1 at the rear. Pull off all of the surrounding trim first.

Just a warning, it is a pain to put back in and get to seal right.

Hope this helps.