Does anyone know of any Mopar documents showing the location of the mounting holes for the Challenger T/A front spoilers? Any measurments from unmolested cars is appreciated as well..understanding that they probably could vary quite a bit though. Thanks much!

There may not be factory drawings since the front spoiler was installed by the dealerships. There might be a better chance of finding a service bulletin that would have been forwarded to the the dealerships from Chrysler Corporate . I checked my factory drawings and they only show installation instructions for the rear spoiler. They may be out there but I couldn't find them in my portfolio of information. Hopefully someone with an original vehicle can provide information from their specific vehicle.

What I understand is that they were shipped in the trunk with an instruction sheet for the dealership to install. The dealership often did not follow the directions, and just put them where they looked good, resulting in many variations. A copy of the instructions sheet has not surfaced for challengers yet.

Still, I'd also be interested in any measurements or pictures people could provide.

Tav

Thanks for the input! Yes, I figured there would likely not be a factory drawing...but perhaps an instruction sheet or some other Mopar document that would spell it out. I have seen the front spoilers in slightly different locations on the T/A's over the years, so perhaps true measurements will be elusive. AAR's are even worse for variations! Our car had no front valance when we started.