need to take the reluctor up/off after getting the center clip out. Have a helper keep the center shaft down w his thumb as you pry the reluctor up w 2 large screwdrivers opposite each other then when it is up a ways switch to 2 tire irons. Dont lose the roll pin & note which groove in the reluctor the roll pin is in. Take out the 2 vac can screws then lift the plate up a bit so the arm can come out/free then remove the can/arm and lever up the bottom plate evenly & take it out from the dist so you can get to the triangle clip on bottom. Make sure the pickup needs R&R'd b 4 you go to this trouble, 1st as said ohm it/check the gap w a brass gauge