Quote:

Best advice...bore, then mock up a piston on each bank and measure depth. You will likely have a different depth on each side like I did. Then take the block to be decked and you should be close to zero, this being your goal...



Definitely the way to go. My 360 block was uneven side to side and unsquare. Ended up taking roughly 10 thou off per side to get it to zero deck, but I had a different reading at each corner.

-Jim

I can fix it... my old man is a television repairman.
He's got the ultimate set of tools... I can fix it.

Currently Mopar-less