Quote:

Quote:

Quote:

Quote:

To the guys that have had to honed-to-fit these things ....what have you used to do-so ?



A small engine hone...



I had it done at the machine shop , he measured it and did it in the rod hone .



X2. ATI recommends .008"-.0011 interference fit. I mic'd the crank and dropped the balancer off at the shop. As it turned out the balancer was within spec as delivered.

These are the instructions that came with a buddy's CCJ balancer:







question on the spec, .008 OR .0008 ??? .008 you would need to use a 100 ton PRESS to get that on ...