Quote:

Did you come to a conclusion on the spacing?



Not a conclusion really, But I do think its more of an issue of the body panels being a little different from one side to the other rather than the rearend being offset in relation to the frame rails.

I just got the new green bearings for my new bbp axles yesterday and finally have it assembled so I can really see where the wheels are going to set.
I also trimmed the width of the fender lip on both sides by a little over 1/8". Laid it out with masking tape, and ground off a little with a disk sander and a 50grit disk.

I think I can live with the clearance I have now, although it is still different from one side to the other.
I have about 1" clearance on pass side, and now have about 1/2" on the drivers side. So I guess I'm not going to worry about moving the rear for now.

This is how the drivers side looks with the lip trimmed back a little.

6550173-S5002754.JPG (87 downloads)