Quote:

I run the Keisler hyd. TOB set-ups, very much the same as the Mcleod 1400/1400-30 set-up,.....having issuses?, or install questions?


Install questtions.
1. I've read and reread the instructions (if you can call that chiicken scratch they give 'instructions') and there's a contradiction on measurements. Basicallly, when everything is installed properly, what should the gap be between the clutch diagphram and the T.O. bearing? I'm reading that it should .150 +/- .050.
2. What size diam. M/C are you using and did any setups NOT work properly fo you.

Thanks.